Corrugated Metal Roofing for Homes, Barns & Outbuildings

Corrugated and ribbed metal roofing for homes, barns, and outbuildings across the Eastern Panhandle, Maryland, and Franklin County, PA. Installed by Jade Roofing & Construction, based in Martinsburg and rated 5.0 on Google.

Corrugated Metal Roofing
Home » Our Services » Roofing Services » Corrugated Metal Roofing

The Working Metal Roof

Corrugated metal roofing is the ribbed, exposed-fastener panel you see on barns, workshops, farmhouse porches, and a growing number of houses around Berkeley and Franklin Counties. It is lighter and less expensive than standing seam, goes down fast, and in a modern galvalume or painted finish it lasts 30 to 45 years with basic upkeep.

The difference between a corrugated roof that lasts and one that leaks in ten years is almost entirely in the fasteners and the details. We use screws with bonded EPDM washers driven at the right torque on the flat of the panel, closure strips at eaves and ridges so wind-driven rain and wasps cannot get under the panel, and proper underlayment on any heated building. On a house we treat it like a house roof, not a shed.

Houses, Barns, Porches, and Shops

Corrugated is a smart choice for farmhouses and outbuildings across the valley, for porch and lean-to roofs where you want the metal look without the standing seam price, and for anyone who wants a straightforward, repairable roof. If you want hidden fasteners and the cleanest possible lines, look at our standing seam page instead.

Installed to Last in Panhandle Weather

Exposed-fastener roofs earn their bad reputation from two mistakes: screws driven crooked or too tight so the washer splits, and panels laid without closures so wind pushes water uphill under the lap. We fix both. Fasteners are set to spec and in straight lines, side laps face away from prevailing weather, and every ridge, eave, and penetration gets a closure or boot. On homes we add a high-temperature synthetic underlayment and, where the slope allows, a vented ridge for the attic.

Panels come in 29-gauge and 26-gauge steel with a galvalume or Kynar-painted finish in the standard reds, greens, greys, and charcoal you see on roofs around here. Jade Roofing & Construction is based in Martinsburg, GAF Certified Plus, a licensed Maryland Home Improvement contractor (MHIC #167279), and BBB Accredited. Corrugated roofs come with the same free inspection and written estimate as every job we do.

Why Jade for Corrugated Metal

Simple roofs still need to be done right. Here is what that looks like on ours.

Fasteners Done Properly

Bonded-washer screws at correct torque, in straight lines, on the flat of the rib. It is the whole game with exposed-fastener metal, and we do not rush it.

Closures and Boots Everywhere

Foam closures at every eave and ridge, pipe boots at every penetration, and sealant only where the manufacturer calls for it. Wind-driven rain stays out.

Honest Advice on Metal

If your house would be better served by standing seam, we will say so. If corrugated is the right call for your barn or porch, we will not upsell you out of it.

Common questions about corrugated metal roofing

What is the difference between corrugated and standing seam metal roofing?

Corrugated (and ribbed R-panel) roofing is fastened with exposed screws through the panel face. Standing seam uses hidden clips under raised seams. Corrugated costs less and is easier to repair; standing seam lasts longer and has no exposed fasteners to maintain. We install both.

With a galvalume or painted steel panel and proper fasteners, 30 to 45 years is typical. Plan on having the screws checked and any weathered washers replaced every 10 to 15 years, which is a quick job we can do during a routine inspection.

On some outbuildings, yes, with furring strips and the right underlayment. On a house we recommend tearing off so we can inspect and repair the deck, and because most local codes limit the number of layers. We will tell you which applies to your building.

Both. We put corrugated metal on barns, shops, garages, run-in sheds, and porch roofs across Berkeley, Jefferson, Washington, Frederick, and Franklin Counties, as well as on houses.

On an insulated house with decking underneath, no more than any other roof. On an open-framed barn you will hear rain on it, which most people consider part of the charm. Hail dents are possible on thinner 29-gauge panels; 26-gauge holds up better.

Brands We Work With

Jade Roofing & Construction is a GAF Certified Plus contractor, an Owens Corning Platinum Preferred Contractor, and a James Hardie Alliance Select Contractor. We install manufacturer-approved systems from GAF, Owens Corning, CertainTeed, DaVinci Roofscapes, Brava Tile, James Hardie, LP SmartSide, ProVia, Alside, and VELUX.